Can I revert back to 3.4.5.28?

BFD3 General Discussion
1

Was on 3.4.5.28 and I came back from vacation, and the license manager decided it needed to check in, as it does from time to time. But it wouldn’t verify anything. When looking into it I found out there was 3.5 was released, but now it needed a different verification process. It didn’t look like I could have license manager reverify my software.

I quickly looked through the forums, and saw a post where someone had updated and everything with old projects worked fine. It’s my fault for not digging a little deeper. I have tracks I need to finish up, and some don’t even load any drum sounds, some only load a few pieces of the kit, I don’t know what’s going on… and I still have no idea that even if all the pieces of a kit load up, that the settings (mixer, trim, etc) carry over. I really just want to go back to the old version as I have some time critical stuff to finish up. UGH!

I’m on windows 10… [Edit: I’m using Reaper as well]

What have I done?!

2

If you pm me I can let you have the 3.4.5.28

Did you update the libraries as well as updating to BFD3.5?

If not, that’s probably why they’re not loading.

If you do update the core libraries and any others that need updating, I would strongly recommend backing up your current libraries as you won’t be able to download them again.

Steve

1 Like
3

TL;DR: Fixed, user error.
I worked out the issues I think. I’m pretty sure what happened is even though I did update the libraries, I did load up a couple projects before that and I think I accidentally saved them in the state where the sounds weren’t loaded. Explains why some projects were fine, too. I’m baffled why I did this, since I always avoid saving a project if there’s a problem on load up. Looks like I’m good to go now, I’ll update if I notice any issues with the older projects going forward. Thanks so much for offering to send the DL.

2 Likes